?、?After driving 1000-1500km, the connecting bolts of the transmission shaft shall be tightened again, and the universal joint shall be lubricated with general lithium grease by hand pressure grease gun, which shall be lubricated regularly later.

　?、?傳動軸在拆卸后再裝配時，必須按傳動軸上的裝配方向標記進行，否則會嚴重影響傳動軸的正常使用。

　?、?When the transmission shaft is reassembled after disassembly, it must be marked according to the assembly direction on the transmission shaft, otherwise it will seriously affect the normal use of the transmission shaft.

　　③ 如需更換傳動軸的零部件，更換后必須重新進行動平衡試驗。

　?、?If the parts of the transmission shaft need to be replaced, the dynamic balance test must be carried out again after replacement.

　?、?使用中如出現傳動軸不平衡現象，應立即停車檢查和修復，以免因其強烈震動而影響整個傳動系的工作，甚至造成嚴重事故。傳動軸市區平衡主要是軸管彎曲、滾針軸承磨損或滑動花鍵裝配不正確等原因造成的。

　　④ In case of unbalanced transmission shaft in use, stop the machine immediately for inspection and repair, so as not to affect the operation of the whole transmission system or even cause serious accidents due to its strong vibration. The urban balance of transmission shaft is mainly caused by the bending of shaft tube, the wear of needle bearing or the incorrect assembly of sliding spline.

　?、?在整車大修時，應注意檢查萬向節在軸承中的松動量及滑動花鍵的磨損情況。當發現十字軸承的徑向和軸間間隙過大、十字軸軸頸上有明顯溝痕或花鍵齒磨損嚴重時，應更換相應總成，必要時更換傳動軸總成。

　?、?During the overhaul of the whole vehicle, pay attention to check the looseness of the universal joint in the bearing and the wear of the sliding spline. When it is found that the radial and inter shaft clearance of the cross bearing is too large, there are obvious grooves on the cross shaft journal or the spline teeth are seriously worn, the corresponding assembly shall be replaced, and the transmission shaft assembly shall be replaced if necessary.

　　以上內容由攪拌車廠家整理發布，更多的相關信息可以點擊官網進行咨詢：http://m.zjchengkao.com.cn/

　　The above content is organized and released by the mixer manufacturer of China Science and Technology Corporation. For more information, please click the official website for consultation: http://www.jufengjiabangji.com/